FETCh Subsystem
Fetch commands return measurement data that has been previously acquired. FETCh queries do not
generate new measurements, but allow additional measurement calculations from the same acquired
data.The data is valid until the next MEASure command occurs.
FETCh[:SCALar]:CURRent[:DC]? (@<chanlist>)
FETCh[:SCALar]:VOLTage[:DC]? (@<chanlist>)
This query returns the DC output current in amperes or DC output voltage in volts. The data returned is
the result of the last measurement command or triggered acquisition. The data is valid until the next
MEASure command occurs.
Parameter Typical Return
<chanlist> one or more channels +1.000000E+01
Returns the measured DC current FETC:CURR? (@1
Returns the measured DC voltage FETC:VOLT? (@1
Keysight MP4300 Series Operating and Service Guide 115
5 SCPI Programming Reference
To Next Page
Loading...
