Kidde FX-64 - Panel Event Programming

Chapter 2: Front panel programming
P/N 3102352-EN • REV 005 • ISS 28DEC18 83
To remove all members from a correlation group:
1. Press the Menu button and choose Programming.
2. Choose Advanced Program and enter the level 2 password.
3 Choose Loop Configuration.
4. Choose Correlation Groups.
5. Enter the number of the correlation group. (Values range from 001 to 199.)
6. Choose Remove All. A warning message is displayed.
7. Choose Continue to remove all members from the group.
— or —
Press the Cancel button to return to the previous level without removing all members.
Note: Removing all members from a correlation group resets the activation count to 1 and
disables in-suite signal silence.
Adding and removing panel events
The following panel events can be added to correlation groups in order to trigger outputs in
that correlation. The outputs activate at the beginning of the event and restore when the events
restore.
• Signal Silence
• Drill
• Common Alarm
• Common Supervisory
• Common Monitor
• Common Disable
• Common Trouble
• Local AC Power
• System AC Power
• Aux Power 1
• Aux Power 2