For detailed information on installa-
tion, contact your local KIOTI Dealer.
A40O4E1A
(1) Rear Weight
(2) Spring Washer
(3) Nut
(4) Bolt
It is possible to inject water and cal-
cium solution into the tire to use it as
a ballast.
If one liter of water is mixed with 0.4
kg of calcium, this liquid does not
freeze down at -49 °F (-45 °C).
For a tire without a tube, fill it with
water and calcium solution at least to
the valve stem level (75%).
If the tire without a tube is not lled
with water and calcium solution suf-
ciently, a part of the rim is exposed,
resulting in corrosion.
For a tire with a tube, ll it up to 90%
of its level.
ADDITIONAL LIQUID TYPE WEIGHT
If the liquid ballast is used, inate
the tire 0.14bar (2psi) more than
the specied pressure.
This is to
compensate for the ventilation
symptom which occurs while the
tire is moving.
The liquid injection should be
performed only by a qualified
service personnel.
For detailed information, contact
your local KIOTI Dealer.
NOTE
NOTE
Attach only required amount
of weight.
Unnecessary weight can result
in poor braking performance,
rapid wear of the brake discs,
shortened axle life, and in-
crease in fuel consumption.
IMPORTANT
Max. load
30 kg×2 Pieces (132 lbs)
To Next Page
Loading...
