CHECKING INTAKE AIR LINE (X)
1. If the hose clamps are loose ,
tighten clamps securely.
2. If the hoses and clamps are dam-
aged, you must replace them at
once. Failure to do so could lead
to engine damage.
3. Check the following section.
(1) Air Line Hose
Section Inspection item
Air cleaner – intake
manifold
Loose clamp and
damaged hose
M55O7C4A
(A) Wheel - to - wheel distance at front
(B) Wheel - to - wheel distance at rear
ADJUSTING TOE-IN (Y)
ADJUSTING PROCEDURE
T46OA36A
READJUSTMENT
(1) Tie Rod Lock Nut (2) Tie Rod
1. Loosen the lock nut and turn the
turnbuckle to adjust the rod length
until the proper toe-in measure-
ment is obtained.
2. Check the toe-in value after the tie
rod is adjusted.
3. Adjust it again if necessary.
M55O782A
1. Park tractor on a at surface
2. Tu rn s t e er i ng w h e el s o f r ont
wheels are pointed straight ahead.
3. Lower the implement, lock the
parking brake and stop the engine.
4. Measure distance between tire
beads (center) at front of tire and
hub height.
5. Measure distance between tire
beads at the rear of tire and hub
height.
6. Front distance should be 2~8 mm
less than rear distance. If not, ad-
just the tie rod length.
To Next Page
Loading...
