(1) Driving mode selection switch
(A) 4WD
M55O4L3A
4WD SWITCH
CAUTION
If the hazard lamps are turned
on for an extended period of
time while the engine is stopp-
ed, the battery can be discha-
rged. Therefore, use them only
in emergency.
The hazard lamp can be oper-
ated without the key inserted.
To avoid accident:
Engage the switch only when
the vehicle is stationary.
While the 4WD is engaged,
dr iv e t he veh ic le w it h l ow
speed as steering and braking
characteristics may differ.
It is possible to engage the
4WD during driving. However,
you may hear noise or feel
slight shift or impact at times
in this case. For safe driving,
engage the 4WD when the trac-
tor is stationary.
The 4WD should not be used
on a paved road as tires can
be worn faster and could cause
damage to front axle.
CAUTION
To e ng ag e the 4WD , p res s t he
switch up. To disengage it, return the
switch.
The 4WD function can be used un-
der the following conditions:
1. If high traction is needed in a wet
area
2. When towing a trailer or using a
loader
The 4WD (4 Wheel Driving) is to
increase traction by driving four
wheels. It is hydraulically operated
by a simple switch operation.
3. When working on a sandy surface
4. When the tractor is pushed out by
reaction from the implement during
cultivating on a hard surface.
5. When cultivating a eld or driving
over a bank
To Next Page
Loading...
