REPLACING TRANSMISSION FLUID AND FILTER (M)
(1) Oil Filter Cartridge
M55O767B
To avoid personal injury, be
sure to stop the engine before
changing the oil or replacing
the lter.
Che ck th e eng ine oi l lev el
before every operation of the
tractor. If the engine oil is in-
sufficient, the engine can be
damaged, and this is not cov-
ered by warranty. Be sure to
add engine oil when its level is
below the lower mark of the oil
dipstick.
Do not dispose of used oil
and oil lter into drainage and
other places not designated by
regulations. Observe applica-
ble regulations when dispos-
ing used oil and lters.
CAUTION
Use only specified engine oil
and KIOTI genuine filter to
insure smooth operation and
durability of the engine.
IMPORTANT
The transmission fluid should be
changed if it is contaminated or after
the transmission is serviced or every
400 hours of operation. When chang-
ing the transmission uid, make sure
to change the uid lter. However, re-
place the lter only at initial 50 hours
and every 200 hours of operation
afterward.
1. Park the tractor on level ground
and start the engine to warm it up.
2. Stop the engine, apply the parking
brake and wait until the oil cools
down.
(1) Drain Plug
M55O768B
3. To drain the used fluid, place the
oil container under the transmis-
sion case and remove the drain
plug to drain used uid. If the uid
does not flow out freely, unscrew
the air bleeding plug on the side
of the hydraulic cylinder on the left
of the top link bracket to facilitate
drainage. Reinstall the drain plugs
securely afterward.
4. Unscrew the fluid filter from the
rear right section on the tractor us-
ing a lter wrench.
To Next Page
Loading...
