FLUSH COOLING SYSTEM AND CHANGING COOLANT (AJ)
1. Stop the engine and let it cool.
2. To drain coolant, remove the drain
plug from the radiator and turn
the radiator cap to the 1
st
notch to
release pressure in the radiator.
Then, remove the cap completely.
3. After all coolant is drained, close
the drain cock.
4. Fill with clean water and anti-
freeze.
5. Install the radiator cap securely.
(1) Drain Cock
M55O7e7A
(1) Reservoir Tank
(A) FULL (B) LOW
6. Add coolant to the reservoir tank
to the "FULL" level.
7. Start and operate the engine for
few minutes.
8. Stop engine and let cool.
9. Check coolant level of reservoir
tank and radiator. Add coolant if
necessary.
To avoid accidents:
Do not remove the radiator
cap while the coolant is hot.
You c an be burne d by h ot
steam. Make sure to remove
it after the coolant is cooled
down enough.
Even though the coolant is
cooled down, turn the cap to
its rst stop and then wait un-
til it is depressurized before
removing the cap completely.
•
•
CAUTION
Coolant capacity
2.4 U.S. gal. (9.1 L)
M55O7A8A
To Next Page
Loading...
