Kioti RX6010C - Checking Engine Oil Level (E)

7
-
10
RX6010C / RX6010PC
H11O606A
(1) Oil Dipstick
(A) Upper Limit (B) Lower Limit
5. Pull out the oil dipstick, clean it,
and then insert it into its original
position. Then, pull it out again and
check if the oil level is within the
specied range.
6. If the oil level is too low, add some
new oil so that the level is within
the allowable range. (Refer to
"Replacing transmission fluid and
lter" in this chapter for uid specs.

If oil level is low, do not run
engine.

Never add the oil over the up-
per limit.

Be sure to check the oil level
after installing hydraulic imple-
ment. Add the uid as needed.

Check the oil level with the
cylinders of an implement ex-
tended and check again with
cylinders retracted. Add the oil
to adjust average oil level in
the range of the oil limit (upper
or lower).
IMPORTANT
(1) Oil Dipstick (2) Engine Oil Filler Plug
(A) Oil level is acceptable within this range
CHECKING ENGINE OIL LEVEL (E)
1. Check the engine oil daily.
2. Park the tractor on level ground
and lower the implement.
3. If the engine was just running,
wait for approx. 5 minutes before
checking the oil level.
M55O7A7A
To avoid personal injury:
Be sure to stop the engine be-
fore checking the oil level.
•
CAUTION
M55-유럽판-07.indd 10 2011-08-10 오후 2:23:32