Do not start engine without
coolant.
Use clean, fresh water and an-
ti-freeze to ll the radiator and
reservoir tank.
When the anti-freeze is mixed
with water, the anti-freeze mix-
ing ratio must be no less than
50% mixture of water and anti-
freeze.
Securely tighten radiator cap.
If the cap is loose or improp-
erly tted, water may leak out
and the engine could overheat.
If the radiator cap has to be
removed, follow the caution
above and securely retighten
the cap.
If the coolant leaks, contact
your local KIOTI Dealer.
IMPORTANT
ANTI-FREEZE
* At 760 mmHg pressure (atmosph-
eric). A higher boiling point is ob-
tained by using a radiator pressure
cap.
This tractor is lled with 50% of eth-
ylene glycol at factory.
If the anti-freeze has been replaced
by tap water later on, the coolant can
freeze, leading to damage to the cyl-
inder and radiator when the ambient
temperature is below zero (32 °F).
Therefore, make sure to change
water into anti-freeze before winter
season comes.
When changing the anti-freeze with
one of another type, ush the cooling
system several times and contact a
professional for the mixture ratio.
The temperatures shown on the
left are industry standards that
necessitate a minimum glycol
content in the concentrated anti-
freeze.
When the coolant level drops due
to evaporation, add water only. In
case of leakage, add anti-freeze
and water in the specied mixing
ratio.
Anti-freeze absorbs moisture.
Keep unused anti-freeze in a
tightly sealed container.
Do not use radiator cleaning
agents when anti-freeze has
been added to the cooling water.
(Anti-freeze contains an anti-
corrosive agent, which will react
with the radiator cleaning agent
forming sludge which will affect
the engine parts.)
NOTE
Vol. %
Anti-
freeze
Freezing Point Boiling Point*
°F
°C °F °C
40
50
-12
-34
-24
-37
222
226
106
108
To Next Page
Loading...
