Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height and
check that at least 1/4 of the
total length of the telescopic
section of the drive shaft is en-
gaged.
WARNING
M55O626A
Ref to the chart below as to installing
of an universal joint.
(1) PTO Cover
(A) Allowable angle of universal joint : 50
˚
The type of PTO
shaft
Allowable angle
of universal joint
SAE 1-3 / 8
"
6
splines
50 degree
To Next Page
Loading...
