SETUP – Configuring Monitor Parameters
5867B_002-626e-04.16 Page 81
4.4.7.5 Configuring Channel X – MP-specific
If an MP requires special measuring channel settings, for instance because a part type needs
a higher filter factor, the corresponding channel parameters can be uncoupled from the
global setup and be set MP-specific.
To achieve this, remove the tick from the checkbox "Use
Settings from GLOBAL SETUP". This will make the
parameters for channel X MP-specific in future. At the
same time the setup menus for the MP-specific setup of
channel X are enabled. The menus and procedure
correspond exactly to those described in GLOBAL SETUP
→ Channel X (see page 28).
Remove tick
To Next Page
Loading...
