249
Installing the Pa3X Amplification System (PaAS)
Installation
Appendix
4. Insert the speaker box’s extruding guide (e) entirely into
the slot (f) on the back of the instrument, being sure the
speaker box is perfectly horizontal.
Be sure the nylon supports (i) for the music stand are per-
fectly resting on the control panel of the instrument (a).
5. When the speaker box (d) is perfectly aligned to the stop-
pers/delimiters, and the fixing pin (j) is over the corre-
sponding hole (k) on the back of the instrument (a), tilt
down the speaker box (d), to make the fixing pin (j) enter
the hole (k).
6. Use the SPEAKER LOCK slider (l) next to the display to
lock (or later unlock) the speaker box (d). When the box is
locked, you must see the closed lock icon ( ). This will
firmly join the speaker box (d) to the instrument (a).
7. At this point, the speaker box is correctly installed. To
remove it, reverse the above instructions.
To Next Page
Loading...
