113
Style Record mode
Exit by saving or deleting changes
Reference
Note: After a record or edit operation, the memory is automati-
cally reorganized. Therefore, when you press START/STOP
there is a delay before you can actually listen to the Style. This
delay is higher with a Style containing more MIDI events.
Note: While in Record mode, the footswitch and EC5 pedals are
disabled. On the contrary, volume/expression-type pedals can
be used.
Exit by saving or deleting changes
When finished editing, you can save your Style in memory, or
abort any change.
• To save changes, select the “Write Style” command from the
page menu (see “Write Style dialog box” on page 138).
• To abort all changes, select the “Exit from Record” command
from the page menu, or press the RECORD button, to exit from
record and return to the main page of the Style Record mode.
Hint: Save often while recording, to avoid accidentally losing your
changes to the Style.
Listening to the Style while in Edit mode
While you are in Style Record mode, you can listen to the
selected Chord Variation or to the whole Style, depending on the
page you are in.
To select a Chord Variation, go to the Main page of the Record/
Edit mode (see “Element (Style Element)” and “Chord Var
(Chord Variation)” on page 114).
• When you are in the Main, Event Edit, Quantize, Trans-
pose, Velocity, or Delete pages, you can listen to the selected
Chord Variation. Press START/STOP to check how it
works. Press START/STOP again to stop the playback.
• When you are in the Sounds/Expression, Keyboard Range,
Chord Table, Trigger/Tension, Delete All, Copy, Style Ele-
ment Controls or Style Control pages, you can listen to the
whole Style. Press START/STOP and play some chords to
do your tests. Select any Style Element using the control
panel buttons (VARIATION 1-4, INTRO 1-3, FILL 1-3,
ENDING 1-3). Press START/STOP again to stop the play-
back.
• When you are in the Guitar Mode page, you can listen to
the pattern you are programming, played in the selected
Key.
Note: While in Style mode, the Fingered 3 Chord Recognition mode
is automatically selected.
List of recorded events
The Style Record mode filters out some events that may cause
wrong operation of the Style. Here are the recorded events, and
the most important filtered-out events.
Note: Some Control Change messages cannot be recorded directly
by using Pa800 integrated controls.
All allowed controllers can be assigned to an Assignable Pedal/
Slider/Switch.
MIDI Control Change messaged inserted by using a software on an
external computer are imported when using the import function
(“Import: Import SMF” on page 135).
Some controllers are reset at the end of the pattern.
Control function CC#
Allowed
Note On
RX Noise On
Pitch Bend
Channel After Touch
Modulation 1
Breath 2
Pan 10
Expression 11
CC#12 12
CC#13 13
Damper (Hold 1) 64
Filter Resonance (Harmonic Content) 71
Low Pass Filter Cutoff (Brightness) 74
CC#80 (General Purpose #5) 80
CC#81 (General Purpose #6) 81
CC#82 (General Purpose #7) 82
To Next Page
Loading...
Need help?
General
