324
Installing the MP3 Board (EXBP-Dual MP3)
Precautions
You can install a Korg EXBP-Dual MP3 board into your Pa800.
This user-installable card will let your Pa800 play and record
MP3 files, allowing for easy music data exchange with any per-
sonal computer or stand-alone MP3 player.
Korg is not responsible for any damage or injury caused by
incorrect installation.
Precautions
• Installation of the card is done at the user’s own risk. Korg will
assume no responsibility for any damage or injury resulting
from its improper installation or use.
• Be sure to disconnect the instrument from the AC plug, before
opening it.
• To prevent your body’s static electricity from damaging the
board’s components, touch an unpainted metallic component
before proceeding with the installation.
Installation
For installation, you will need a cross-point screwdriver and a pair
of pliers (not supplied).
1. On the back of the instrument, unscrew the two screws (a)
and extract the cover (b), to gain access to the MP3 Board
slot.
2. Fully remove the cover (b) by unfasteing the ground cable
(c). Be very careful not to let the ground cable (c) and the
attached power cable (d) fall inside the instrument.
3. Extract the MP3 card (e) from its package, being careful
not to touch any component on its surface with your fin-
gers. Connect the ground cable (c) and the power cable (d)
to the corresponding connectors on the MP3 card, as
shown in the illustration.
Installing the MP3 Board (EXBP-Dual MP3)
To Next Page
Loading...
Need help?
General
