XI - 10
Maintenance and Care
BMII-184
1
2
3
Capacity: approx.80 l (approx. 21 U.S. gal)
11.15 Hydraulic oil level
11.16 Replacing hydraulic oil filter
Observe absolute cleanliness when
changing the filter
Replace the filter element (1) every 500 operating hours
or after each mowing season (with the hydraulic oil
change).
Loosen filter and unscrew.
Replace the filter with a new filter.
Screw on new filter as follows:
Wet sealing surface of filter with oil.
Once the filter seal touches the sealing surface of the
filter housing, tighten the filter by 3/4 to 1-1/4 turns by
hand. Do not overtighten.
Check filter for leaks while the engine is running and
tighten if necessary.
BMII-183
1
2
3
Lower all mowers and turn off engine.
Oil inspection
Time interval: every 50 h
Oil must be visible in the inspection window (1).
If necessary, top up oil (2)
Oil change:
Time intervals: every 500 h or at filter warning indicator,
however at lease once per year
Drain oil with suitable hose via plug-in connection (3)
Collect the used oil in a suitable collection vessel.
Fill oil (2)
Oil level (Oil must be visible in inspection window (1).)
To Next Page
Loading...
