Krone Big M II - Starter Maintenance; Fuse Locations and Identification

XII - 4
Maintenance - Electrical System
12.10 Starter
Before carrying out work on the
electrical system or on the engine,
always disconnect the earth cable or
disconnect with the battery main switch
to avoid damage.
If the starter fails or does not work properly, find the cause
of the problem.
If the suggestions below do not solve the problem, contact
your KRONE dealer. Have the starter checked thoroughly
once per year at a specialist workshop.
Loose, dirty or corroded cable connections:
 clean and tighten cable connections on the starter.
 Clean the earthing wires on the motor and tighten the
connection to the motor.
Battery power too weak:
 check electrolyte level as well as acid density, recharge
battery if necessary.
Flat battery:
 Charge battery.
Use of incorrect engine oil viscosity:
 Always use the right engine oil according to the
specifications.
Faulty starter safety relay:
 Replace relay.
sfm0530
0
12.11 Fuses
The fuses are at a central point in the control box (3) on a
board.
SFM1-14
0
1
3 4
2
Only allow Krone customer service
or a dealer to carry out work on the
electronics!
Fuse and relay designations can be found on the circuit
board.