XIV - 1
Storage
14 Storage
14.1 At the End of the Harvest
Season
If possible, park the self-propelled high-performance
mower-conditioner in a protected and dry place.
Clean the self-propelled high-performance mower-
conditioner on the inside through the maintenance
openings and on the outside. Chaff and dirt attract
moisture causing steel parts to rust.
If a high pressure washing device is
used, do not direct the water jet into the
bearings or electrical/electronic parts.
Lubricate the self-propelled mower according to the
lubrication chart. Grease the threads of adjusting
screws and similar parts; relieve springs. Transport
locking catch for lateral mowers: Grease the bolt.
Grease the blank piston rods of all hydraulic cylinders
and retract as far as possible.
Wet all lever joints, cutterbar and bearing points
without lubrication with oil.
Write down all maintenance work which has to be carried
out before the next harvest and send order in good time.
Your KRONE dealer can carry out servicing work and
any necessary repairs outside the harvesting time.
To Next Page
Loading...
