Krone Big M II - Setting Cutting Height; Setting Ground Pressure

X - 3
Mowers
The cutting height is set individually for each mower:
The tilt of the disc mowers and thus the cutting height is
adjusted via threaded spindles. There is an extension pipe
in the tool box.
Front mower
Cutting height can be varied by adjusting top link (1).
Longer top link arm = shorter cutting height
Shorter top link arm = longer cutting height
Adjustments must always be made
only when the drive is switched off
and the tractor engine is at a stand-
still! Remove the ignition key!
Secure the tractor against rolling
away.
10.2.3 Setting the Cutting Height
Side mowers
 Disassemble the lynch-pin (1).
 Remove the securing ring (2).
 Adjust the direction of adjustment ratchet (4) rotation on
the lever (3).
 Lengthening the threaded spindle produces a smaller
cutting height.
 Shortening the threaded spindle produces a greater
cutting height.
BM201290
1
2
3
4
BM201270
3
1
2
 Turn the threaded spindle (3) until the securing ring (2)
can be inserted.
 Secure the securing ring (2) with the lynch-pin (1).
BMII-188
1