Krone Big M II - Setting Transverse Link on Side Mowers; Front Mower Guiding Plates

X - 9
Mowers
With a cutting heigt of 0°, the distance
"a" between the side plate (4) and the
extension arm (5) must not be less than
60 mm.
10.2.10 Setting the transverse link on side
mowers
Use the transverse link (1) to orient side mowers (3).
 Loosen the lock-nut (2) on the transverse link (1).
 Adjust the transverse link (1) until the distance a
between the side mower (4) and the extension arm (5)
is set to 60 mm.
 Tighten the lock-nut (2) on the transverse link (1).
BM201180
2
3
1
4 5
a
BM201120
1
2
3
4
10.2.11 Front mower guiding plates
There are guiding plates situated in front mowers (3) in the
area of the swath former (2). These are fitted to the housing
with fixture screws (1).
 If the swath is not deposited uniformly, check whether
the guiding plates (4) are distorted and readjust if
necessary.