XVI - 2
Lubrication Chart - Periodical Maintenance
16.2.2 Until the First 50 Operating Hours
have been Reached
Tighten the front wheel nuts and rear wheel hub
mounting bolts with 700 Nm (518 lb-ft).
16.3 Only after the First 100 Opera-
ting Hours
Carry out all maintenance work which is listed under Every
10 Operating Hours.
Change engine oil and filter.
Other ranges see the Operating instruction of the
engine
Check or adjust drive belt tension.
Check that the hoses and hose clips on the air intake
and cooling system are secure.
Check fuel injection lines for loose connections.
Change central gearbox oil.
Clean valve cover ventilation.
Check the cooling system antifreeze mixture, top
up antifreeze mixture if necessary.
Check foot brake setting.
Adjust parking brake Bowden cable if necessary.
Check that turbo charger screw connections and
hose connections are fitted properly.
Clean the paper filter elements in the cab.
Check the oil level in the central gearbox.
Check the oil level on the cutterbar
16.4 Every 250 Operating Hours
Includes all work described under
Every 10 Operating Hours.
Tighten wheel nuts with 700 Nm (518 lb-ft).
Tighten the mounting bolts on the steering cylinder.
Tighten the mounting bolts on the track rod.
Replace fuel filter.
Drain engine oil from crank case, fill with new oil.
Replace engine oil filter.
Check the battery acid density, recharge the battery if
necessary and top up destilled water.
For precise maintenance
recommendations for the engine, see the
separate maintenance instructions
"Daimler Chrysler Wartungsheft".
To Next Page
Loading...
