VIII - 3
Engine Operation
8.6 Starting Engine
Only start the engine from the operator's
seat.
Turn the starter switch to position II. Release the key
as soon as the engine starts. Never hold the key in the
start position for longer than 20 secs.
If you turn the key switch to position I before the engine
starts, wait until the engine has come to a standstill before
attempting to start again.
If the engine does not start within
20 secs., wait at least 2 min. before
attempting to start again.
BMII-177
1
BMII-177
1
8.5 Switching On Ignition
II - The ignition is switched on
The following indicator lights will illuminate:
Engine failure indicator light (2) for approx. 2 seconds
Job computer carries out internal system check
The basic display appears
Job computer carries out an internal system check.
The standard display appears.
8.4 Switching on the Circuit for the
Electronics
I - Circuit for the electronics is switched on
To Next Page
Loading...
Need help?
General
