X - 7
Mowers
Setting the Roller Spacing
Loosen the lock nut (1) (spanner size 24) and turn the
adjusting nut (2) (spanner size 46) on the threaded
spindle (3).
Turn clockwise = lager spacing
Turn anticlockwise = smaller spacing
Tighten the lock nut again.
10.2.8 Setting the Roller Conditioner
(optional equipment / Big M CRi)
General
The roller conditioner is intended for operation in legumes
and other leaf vegetables.
The conditioner intensity is set using adjusting spindles (1)
which are used to change the spacing and application
force of the rollers. The minimum spacing between the
rollers should always be at least 2 mm.
2
1
3
Always check the conditioner roller (1) for damaged
V-tines (2) before operation.
Straighten bent tines.
Replace broken tines.
Check bearing pins and bushing on tine mountings. To
avoid losing tines, replace bearing pins and bushings in
good time!
The conditioner shaft turns at up to
approx. 1000 r.p.m. Bent and broken
tines cause unbalanced rotation. For
this reason replace broken V-tines
immediately.
10.2.7 Setting the Conditioner Cover Plate
(Big M CV)
The conditioning effect of the mowing crop can be in-
fluenced by adjusting the conditioner cover plate using the
screw (1). Turning clockwise increases the conditioner
effect with an increase in power consumption. Turning the
screw anticlockwise reduces the conditioning effect.
Adjust the conditioner cover plate with the adjustment
pin (1) in side mowers.
To Next Page
Loading...
