XV - 2
Belt Drive
Replacing the V-belt on deployment arms.
Dismantle the belt covers.
Relax the spring (1) on the tension pulley.
Dismantle the cover (3) on the right-
hand side.
Loosen the lubrication wire (2).
Exchange the belt (4) and test that they are in the
correct position.
Stretch spring (1) to a length of 90 mm.
Mount the cover (3) on the right-hand side.
Mount the belt covers.
15.3 Mower drive
Belt tension is generated using the hydraulic cylinder
(pressure 50 bar).
Reset the single action cylinder using the springs.
BMII-218
BM201050
1
3
4
2
To Next Page
Loading...
