II - 4
Safety
2.11 Tyres
1. When working on the tyres, make sure that the
implement has safely lowered and been secured
against rolling (wheel chocks).
2. Installing wheels and tyres requires adequate
knowledge and suitable tools!
3. Repair work on the tyres and wheels should be done
by specially trained personnel using appropriate
installation tools only!
4. Check tyre pressure regularly! Inflate the tyres
to the recommended pressures!
5. Check wheel nuts pressure regularly! Missing wheel
nuts can lead to a wheel falling off and the machine
tipping over.
2.12 Emergency Exit
An emergency hammer is located inside the cabin. In
case of an emergency use this hammer to smash the
right side-window.
2.13 Maintenance
1. Always make certain that the drive and the engine
are switched off before doing any repairs, main-
tenance or cleaning!
- Remove the ignition key!
2. Regularly check that nuts and bolts are properly
seated and tighten if necessary!
3. When carrying out maintenance work on a raised
mower, always use suitable means to secure it
against falling.
4. When replacing working tools with cutting edges,
use suitable tools and gloves!
5. Dispose of oils, greases and filters according to
regulations!
6. Always disconnect the power supply before working
on the electrical system!
7. If protective devices and guards are subject to wear,
check them regularly and replace them in good time!
8. When doing electrical welding on the self-propelled
high performance mower-conditioner and attached
implements, disconnect the power supply at the
main battery switch.
9. Replacement parts must at least comply with the
technical requirements set by the manufacturer of
the implements!
This is ensured by using genuine
KRONE replacement parts!
10. Only use nitrogen for filling pneumatic accumulators
- Risk of explosion!
2.14 Unauthorised Modification
and Manufacture
of Replacement Parts
Modifications to the machine are permitted only with
the prior approval of the manufacturer. Genuine
replacement parts and accessories authorized by the
manufacturer ensure safe use. Use of other parts may
void liability for damage which results.
2.15 Prohibited Modes of Operation
The operational safety of the machine is guaranteed only
if it is used for its intended purpose in accordance with
the General Information chapter of the operating manual.
The limit values listed in the data charts should not be
exceeded under any circumstances.
To Next Page
Loading...
