The belt is changed from the rear of the mower.
The rear protective hood does not have
to be removed for this.
Remove the rear cover plate from the gearbox shaft.
Relieve the belt (4) by loosening the nuts (1) on the belt
tensioner
Fold the tensioning roller (2) back.
Remove the screw (3) on the upper belt pulley (6).
Remove the belt from the lower belt pulley (5) and then
pull out towards the top.
Reassemble in reverse order.
Damaged drums or discs lead to un-
balanced rotation and thus to damage.
Replace immediately!
The tension spring for the belt should
on the CV version have a measurement of 215 mm
on the CRi version have a measurement of 290 mm
A
CRI-0-004
10.5 Conditioner Belt Drive
Clean the cover casing (2) of the belt drive at regular
intervals.
Push the cover plate (1) to one side and clean the cover
casing (2) (air jet).
Close the opening in the cover casing (2) again with the
cover plate (1).
BM201090
1 2
To Next Page
Loading...
