X - 15
Mowers
10.4 Changing Blades on the cutterbars
Oil change on the cutterbar
Use a suitable collecting vessel
Remove cover (2) at the cutterbar end.
Lower the cutterbar on this side
Drain oil
Reinstall cover (2) with new seal.
Fill oil through check screw hole (1)
Align the cutterbar horizontally crosswise and
lengthwise before checking the oil level (see Oil
check)
Oil quality: see section 10.3.4
Tank capacity: see section 10.3.4
EC-0-051
10.4.1 Special Safety Instructions
Dispose of used oil properly!
Check the oil after any repair work on
the cutterbar.
Change oil in the mower beam after the
first use and then every : 100 operating
hours.
The cutter blades can continue to rotate
after the drive has been switched off.
Only approach once the work tools have
come to a complete standstill!
Only carry out work on the mower if the
PTO shaft has been disengaged, the
engine turned off and the ignition key
removed! Secure the tractor against
unintended start-up and against rolling.
Safe operation is only guaranteed if the
cutter blades have been fitted properly!
Only replace missing and damaged cutter blades
in sets so there is no unbalanced rotation.
Never fit unevenly worn cutter blades on a drum/
disc!
Also check retaining components each time you
change the cutter blades and replace them if
necessary!
DO NOT TAKE RISKS!
Only use original KRONE spare parts.
Always check the mower for damaged, missing
or worn cutter blades before operation, replace
cutter blades if necessary! This applies for
retaining components.
To Next Page
Loading...
