X - 14
Mowers
EC-0-001
EC-0-003
Switch off engine. Remove ignition
key.
10.3.10 Oil level inspection and oil change on
the cutterbar
Lengthwise
Lay the spirit level (1) on two cutting discs.
Oil level check
Align the cutterbar using a spirit level (1).
Crosswise
Lay the spirit level on the cutting disc hub parallel to the
direction of travel.
Oil level up to bore hole. If necessary, top up oil (SAE
90), fit check screw
Carrying out oil check
Lower guards. Nobody should be in
the danger zone around the machine.
Switch off engine. Remove ignition
key.
Allow the machine to run briefly. Wait until the cutterbar
has come to a standstill.
Remove the oil check screw (1) on the cutterbar.
Check the oil level before every operation.
EC-0-002
To Next Page
Loading...
