EasyManua.ls Logo

Krone Big M II - SmartDrive Error Codes (Continued)

Krone Big M II
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
XII - 15
Maintenance - Electrical System
No. Picture Remark Relief
Limp-Mod
e
36 Brake pressure sensor error:
Signal out of range
- Check brake pressure sensor
and brake pedal switch
- Check wiring
- Replace brake pressure sensor
- Replace brake pedal switch
X
37 Pump Speed
reading Value too
low!
Pumps speed too low - Check wiring
38 Brake reservoir pressure to
low
39 Error on Can bus
communication!
CAN bus communication error - Check wiring
40 High pressure
sensor Signal out of
range!
High-pressure sensor: Signal
out of range
- Check wiring
- Replace high-pressure sensor
42 An attempt was made to drive
against the parking brake
- Parking brake switch not in
normal position
- Check parking brake switch and
wiring
- Check sensor and wiring
- Replace sensor
X
43 Feeding pressure too high - Check wiring
- Replace sensor
44 Oil temperature too high - Let machine cool down
- Check wiring
- Replace sensor
X
45 An attempt was made to drive
without drive release
- Drive release switch is not
switched on
-Check drive release switch and
wiring
X
46 Error on Pump 1
solenoid 1!
Pump 1 control valve 1 error - Check wiring
47 Error on Pump 1
solenoid 2!
Pump 1 control valve 2 error - Check wiring
48 Error on Pump 2
solenoid 1!
Pump 2 control valve 1 error - Check wiring
49 Error on Pump 2
solenoid 2!
Pump 2 control valve 2 error - Check wiring
50 Error on Joystick! Joystick: Signal wrong / faulty - Check joystick
- Replace joystick
- Replace KKC
X

Table of Contents

Related product manuals