Chapter 1 Before You Install the InTouch
10
Contents of the kit
The contents of your kit may vary depending on the model and the options
ordered for your site. For example, the Standard model transformer and Slim
Profile wall transformer are separately orderable items.
The bag of hardware is the same for the two models except where noted:
Part Quantity Where Needed
Maintenance badge 1 Supplied for magnetic stripe, HID
proximity, bar code, and smart card
readers.
10 x1 1/4 self-tapping screw
Plastic wall anchors
3
3
• Standard model: “Step 3: Mount the
base” on page 31
• Slim Profile model: “Step 3: Mount the
base” on page 68
Ethernet strain relief clip
M3 x 10 screw
1
2
• Standard model: “Connect Ethernet
cable” on page 48
• Slim Profile model: “Step 7: Connect
power and cables to the main board” on
page 77
Strain relief clip Standard: 2
Slim Profile: 1
• Standard model: “Secure the cables
with the strain relief clip” on page 51
• Slim Profile model: “Step 6: Secure the
cables with the strain relief clip” on
page 73
Security wrench (torx)
M4 x10 torx screw
1
1
• Standard model: “Close the cover and
secure the screws” on page 57
• Slim Profile model: “Close the cover
and secure the screws” on page 81
SEMS M3 x 6 screw 3 • Standard model: “Install the transition
board option kit” on page 40 and “Step
6: Attach the plastic transformer plate”
on page 43
• Slim Profile model: N/A
To Next Page
Loading...