Chapter 3 Install the Slim Profile InTouch
68
Step 3: Mount the base
After you prepare the location, mount the base of the InTouch to the wall.
1. Do one of the following:
To mount the base on wood:
a. Drill pilot holes for the top two mounting screws and the bottom
mounting screw (three 10X1-1/4 screws are included with the InTouch).
See the examples on the following pages.
b. Use a drill or screwdriver to drive the top two mounting screws into the
wall, leaving 1/4 inch (6 mm) between the head of each screw and the
wall.
To mount the base on drywall:
a. Use a 9/32 inch drill bit (7 mm) to drill holes for the three wall anchors
(included with the InTouch). See the examples on the following pages.
b. Install a wall anchor in each screw hole. Push or tap the wall anchors until
they are flush against the wall.
c. Use a drill or screwdriver to drive the top two mounting screws (three
10X1-1/4 screws are included with the InTouch) into the wall, leaving 1/4
inch (6 mm) between the head of each screw and the wall.
To Next Page
Loading...