Appendix B
Open and Disconnect the InTouch
If you need to open the InTouch to use the internal startup or Maintenance mode buttons,
access the circuit boards or cables, or add, remove, or replace any components, use this section
for the general procedure. You may not need to perform all of the steps or remove all
components, depending on the maintenance or installation task you need to perform.
Important:
• If you need to return the InTouch or any of its options, follow the procedures in the Guide
to Returning the InTouch.
• You may need an extra person to hold the cover assembly while you perform some of the
steps.
• Required tools: Security wrench that came with the InTouch and small Phillips and slotted
screwdrivers.
To Next Page
Loading...