KTM 690 SMC R User Manual

8 RIDING INSTRUCTIONS 48
Info
Do not press the electric starter button until the combination instrument func-
tion check is finished.
When starting, DO NOT open the throttle. If you open the throttle during the start-
ing procedure, fuel is not injected by the engine management system and the
engine cannot start.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds before
trying again.
This motorcycle is equipped with a safety starting system. You can only start
the engine if the transmission is in neutral or if the clutch lever is pulled when
a gear is engaged. If the side stand is folded out and you shift into gear and
release the clutch, the engine stops.
– Take the weight off the side stand and swing it back up with your foot as far as it will
go.
401426-11
Switching off ABS
KTM recommends riding with ABS at all times. However, situations may arise in which
ABS is not advantageous.
Condition
Vehicle stationary, engine running.
–
Press button

for 3 – 5 seconds.
The ABS warning lamp starts flashing; ABS is deactivated.

KTM 690 SMC R Specifications

General

Engine Type	Single-cylinder, 4-stroke
Bore x Stroke	105 mm x 80 mm
Compression Ratio	12.7:1
Starter	Electric starter
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Cooling System	Liquid cooled
Frame	Chromium-Molybdenum steel trellis frame, powder coated
Front Wheel	3.50 x 17"
Rear Wheel	5.00 x 17"
Front Tire	120/70 ZR 17
Rear Tire	160/60 ZR 17
Seat Height	890 mm
Power	55 kW (74 hp)
Torque	73.5 Nm
Front Suspension	WP APEX 48
Rear Suspension	WP APEX with Pro-Lever linkage
Front Brake	Single 320 mm disc, 4-piston caliper
Rear Brake	Single 240 mm disc, 1-piston caliper
ABS	Bosch 9.1 MP (lean angle sensitive)
Fuel Tank Capacity	13.5 liters
Dry Weight	147 kg