13 WHEELS, TIRES 100
13.1 Removing the front wheel
Preparatory work
– Raise the motorcycle with the rear wheel stand. ( p. 70)
– Raise the motorcycle with the front wheel stand. ( p. 71)
101995-10
Main work
–
Remove screw
and pull wheel speed sensor
out of the hole.
–
Remove screws
and spacers
.
– Press back the brake linings with a light lateral tilting of the brake caliper on the brake
disc. Pull the brake caliper carefully back from the brake disc and hang it to one side.
Info
Do not pull the hand brake lever while the brake caliper is removed.
101996-10
–
Loosen screw
and screws
.
–
Unscrew screw
about 6 turns and press your hand on the screw to push the wheel
spindle out of the axle clamp. Remove screw
.
Warning
Danger of accidents Reduced braking efficiency due to damaged brake disc.
– Always lay the wheel down in such a way that the brake disc is not damaged.
– Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of the
fork.
To Next Page
Loading...
