KTM 690 SMC R - Adjusting the Basic Position of the Shift Lever

16 TUNING THE ENGINE 143
16.3 Adjusting the basic position of the shift lever
401950-12
–
Remove screw

with washers and take off shift lever

.
401951-10
–
Clean gear teeth

of the shift lever and shift shaft.
–
Mount shift lever

on the shift shaft in the required position and engage the gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other vehicle components
during the shift procedure.
–
Locate and tighten screw

with washers.
Guideline
Screw, shift lever M6 14 Nm
(10.3 lbf ft)
Loctite
®
243™