Kubota 07-CR-E5 - Page 122

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S84
9Y3200007CRS0122US0
Name Engine overheat Engine overrun
ISO 14229
P-Code
P0217 P0219
J1939-73
SPN 110 190
FMI 00
SPN Name
SAE J1939 Table C1
Engine Coolant Temperature Engine Speed
DTC Name Engine overheat Engine overrun
Detection item • Overheat of engine coolant temperature • Engine speed exceeds threshold speed
DTC Set
Preconditions
• Coolant temperature sensor is normal • Key switch is ON
DTC set parameter
• Engine coolant temperature ≥ 120 °C
(248 °F)
• Engine speed ≥ 3500 min
-1
(rpm)
Time to action or
number of error
detection
• 5 sec. or more • 3 revolutions or more
Limp Home Action
by engine ECU
(system action)
• Output limitation: Approximately 75 % of
normal condition
•EGR stop
• Intake throttle 100 % open
• Stop injection (Q = 0 mm
3
/st)
Behaviour During
Malfunction
• Insufficient output
• Overheat
•Overrun
Engine Warning
Light
•ON •ON
Recovery from
error
• Diagnostic counter = zero
or Key switch turn OFF
• Diagnostic counter = zero
or Key switch turn OFF
Delay time for
recovery
• 30 sec. • Immediately
Remark
KiSC issued 03, 2022 A