EasyManua.ls Logo

Kubota 07-CR-E5 - Boost Pressure Sensor Abnormality (DTC P0237; 102-4, P0238; 102-3)

Kubota 07-CR-E5
373 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S187
(19) Boost Pressure Sensor Abnormality (DTC P0237 / 102-4, P0238 / 102-3)
P0237 / 102-4: Boost pressure sensor: Low
Behaviour during malfunction:
Insufficient output
Detection item:
Ground short circuit of sensor / harness
Failure of sensor
DTC set preconditions:
Battery voltage is normal
Sensor supply voltage VCC# is normal
DTC set parameter:
Voltage of boost pressure sensor is 0.2 V or below
Engine warning light:
•ON
Limp home action by engine ECU (system action):
65 kPa (0.66 kgf/cm
2
, 9.4 psi) [default value]
Recovery from error:
Key switch turn OFF
9Y3200007CRS0256US0
P0238 / 102-3: Boost pressure sensor: High
Behaviour during malfunction:
Insufficient output
Detection item:
Open circuit or +B short circuit of sensor / harness
Failure of sensor
DTC set preconditions:
Battery voltage is normal
Sensor supply voltage VCC# is normal
DTC set parameter:
Voltage of boost pressure sensor is 4.9 V or above
Engine warning light:
•ON
Limp home action by engine ECU (system action):
65 kPa (0.66 kgf/cm
2
, 9.4 psi) [default value]
Recovery from error:
Key switch turn OFF
9Y3200007CRS0257US0
KiSC issued 03, 2022 A

Table of Contents

Related product manuals