COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S297
(58) Excessive PM3 (DTC P3006 / 3701-15)
Behaviour during malfunction:
• Insufficient output
Detection item:
• PM accumulation level 3
DTC set preconditions:
• Battery voltage is normal
DTC set parameter:
• PM accumulation more than trigger level
Regeneration level = 3
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Output limitation: Approximately 50 % of normal condition
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0463US0
1. DPF Manual Regeneration
1. Start DPF Manual Regeneration immediately.
• This DTC means the warning to urge to start regeneration
rather than error. (Basically, Service Call is not necessary.)
• Followings are potential causes.
– A low load operation has been continuing.
– An engine is often left idling.
– A short time operation below 30 minutes has been
continuing.
9Y3200007CRS0464US0
(a) DPF Manual Regeneration
Reguest Button