Kubota 07-CR-E5 - Crankshaft Position Sensor (NE Sensor) Abnormality (DTC P0335; 636-8, P0336; 636-2)

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S191
(20) Crankshaft Position Sensor (NE Sensor) Abnormality (DTC P0335 / 636-8,
P0336 / 636-2)
P0335 / 636-8: No input of NE sensor pulse
Behaviour during malfunction (Running only with G signal):
• Faulty starting
• Vibration is slightly large
• Insufficinet output
Detection item:
• Open circuit or short circuit of sensor / harness
• Failure of sensor
DTC set preconditions:
• Battery voltage is normal
• Sensor supply voltage VCC# is normal
• Engine is not stalled
DTC set parameter:
• No recognition of Ne sensor pulse
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Output limitation: Approximately 75 % of normal condition
NOTE
• Engine will stop if both NE and G fail
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0264US0
P0336 / 636-2: NE sensor pulse number error
Behaviour during malfunction (Running only with G signal):
• Faulty starting
• Vibration is slightly large
• Insufficinet output
Detection item:
• Open circuit or short circuit of sensor / harness
• Failure of sensor
DTC set preconditions:
• Battery voltage is normal
• Sensor supply voltage VCC# is normal
•350 min
-1
(rpm) or higher
DTC set parameter:
• Pulse count per rotation is not 56 teeth
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Output limitation: Approximately 75 % of normal condition
NOTE
• Engine will stop if both NE and G fail
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0265US0
KiSC issued 03, 2022 A