COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S298
(59) Excessive PM4 (DTC P3007 / 3701-16)
Behaviour during malfunction:
• Insufficient output
Detection item:
• PM accumulation level 4
DTC set preconditions:
• Battery voltage is normal
DTC set parameter:
• PM accumulation more than trigger level
Regeneration level = 4
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Output limitation: Approximately 50 % of normal condition
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0465US0
1. DPF Manual Regeneration Reguest Function
1. Perform the diagnosis tool active test ("DPF Manual
Regeneration").
• Followings are potential causes.
– A manual regeneration has not been carried out. Start
DPF manual regeneration immediately when the
manual regeneration warning light comes ON.
9Y3200007CRS0466US0
(a) CAN1 Connector
To Next Page
Loading...
