Kubota 07-CR-E5 - Parked Regeneration Time out (DTC P3013; 523590-16)

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S303
(63) Parked Regeneration Time Out (DTC P3013 / 523590-16)
Behaviour during malfunction:
•None
Detection item:
• Time out error: regeneration imcomplete due to low temperature of DPF
DTC set preconditions:
• During parked active regeneration mode
• Coolant temperature is 50 °C (122 °F) or more
DTC set parameter:
• Regeneration process is not completed within 2700 sec.
Engine warning light:
•ON
Limp home action by engine ECU (system action):
•None
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF (Leaving from parked active regeneration status)
9Y3200007CRS0477US0
1. Check the Installation of Exhaust Gas Temperature sensor
1. Check the installation of all exhaust gas temperature sensors
(T
0
, T
1
and T
2
).
2. Check the installation condition of the thermostat, and whether
rust is not occurred.
3. Reinstall or replace the thermostat as necessary.
9Y3200007CRS0478US0
2. DPF Manual Regeneration
1. Place the key switch in the OFF position, and attach the
diagnosis tool to the CAN1 connector.
2. Turn the key switch to the ON position and select the "Exhaust
Gas Temperature Sensor 0", "Exhaust Gas Temperature
Sensor 1" and "Exhaust Gas Temperature Sensor 2" on the
data monitor.function.
3. Perform the diagnosis tool active test ("DPF Manual
Regeneration").
9Y3200007CRS0479US0
OK Go to "2. 2. DPF Manual Regeneration".
NG Replace the exhaust gas temperature sensor or thermostat. (Follow the
diagnostic procedure of items P0543, P0546 and P242C)
(1) Exhaust Gas Temperature
Sensor T
0
(2) Exhaust Gas Temperature
Sensor T
1
(3) Exhaust Gas Temperature
Sensor T
2
(A) Exhaust Inlet Side
(B) Exhaust Outlet Side
Service
specification
No DTC is output.
OK Normal.
NG Go to 3. Check the Exhaust Gas Temperature Sensors (Refer to items
P0543, P0546 and P242C)".
(a) CAN1 Connector
KiSC issued 03, 2022 A