Kubota 07-CR-E5 - Initial Pump-Calibration Incomplete (DTC P3019; 523600-0)

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S308
(66) Initial Pump-calibration Incomplete (DTC P3019 / 523600-0)
Behaviour during malfunction:
• None
Detection item:
• Pump-calibration history
DTC set preconditions:
• Battery voltage is normal
DTC set parameter:
• Initial pump calibration incomplete
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• None
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0484US0
1. Initial Pump-calibration
1. Place the key switch in the OFF position, attach the diagnosis
tool the CAN1 connector, and perform the supply pump learning
on the utility function.
NOTE
• This warning indicates that supply pump learning not
performed after replacing engine ECU on the site.
9Y3200007CRS0485US0
(a) CAN1 Connector
KiSC issued 03, 2022 A