Kubota 07-CR-E5 - Page 143

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S105
9Y3200007CRS0569US0
Name Battery voltage too low
ISO 14229
P-Code
P1C04
J1939-73
SPN 168
FMI 1
SPN Name
SAE J1939 Table
C1
Battery voltage too low
DTC Name Battery voltage too low
Detection item
• Open circuit, short circuit or damage of harness
• Failure of battery
DTC Set
Preconditions
• Key switch is ON
• Starter switch signal (ECU: V12 terminal) is not activated
DTC set parameter
• ECU recognition of battery voltage is below 6 V in 12 V system
• Not monitored during cranking
Time to action or
number of error
detection
• 2 sec. or more
Limp Home Action
by engine ECU
(system action)
• Engine Stop
Behaviour During
Malfunction
• Engine stops
Engine Warning
Light
•ON
Recovery from
error
• Key switch turn OFF
Delay time for
recovery
–
Remark • Engine ECU (Kubota) dedicated DTC
KiSC issued 03, 2022 A