Kubota 07-CR-E5 - Page 218

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S180
3. Replacing the Engine ECU and Checking Whether the DTC Is
Detected Again
1. Replace the engine ECU.
2. Turn the key switch OFF and then ON again.
3. After clearing the DTC, turn the key switch OFF and then ON
again, and start the engine.
4. Check whether or not the same DTC (P0200) is detected.
9Y3200007CRS0243US0
Service
specification
DTC is not detected.
OK Engine ECU fault → Replace the engine ECU.
(a) CAN1 Connector
KiSC issued 03, 2022 A