Kubota 07-CR-E5 - Page 66

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S28
*1: When the engine rotation change is large, it lights.
*2: It lights for a timing positional wrong gear.
9Y3200007CRS0022US0
Malfunction Cause
Malfunction Cause
Control System Engine
Crankshaft position sesor Camshaft position sensor Accelerator position sensor Coolant temperature sensor
Low compression pressure Engine internal fault Valve clearance fault Valve timing fault Low engine oil viscosity Insufficient engine oil level No signal output Damaged sensor pulsar gear Air gap size is too large No signal output Damaged sensor pulsar gear Air gap size is too large No signal output False signal output Misadjustment No signal output False signal output
1
Engine Warning
Light Comes On
 

*1

*1

*2
2
Engine Does Not
Start
  
3
Takes A Long
Time Before
Engine Starts
  
4 Idle Failure    
5 Engine Noise  
6
High Fuel
Consumption
 
7
Poor
Acceleration
(Insufficient
Output)
 
8
Black Smoke
Emitted
 
9
White Smoke
Emitted
 
10
Engine Stalls On
Deceleration
  
KiSC issued 03, 2022 A