Kubota 07-CR-E5 - Page 72

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S34
8. Supply Pump Learning and Checking the Monitor
1. Perform learning for the supply pump in accordance with "3.
ACTIVE TEST AND UTILITY". (Refer to page 1-S17)
2. In accordance with the previous "List of malfunction causes by
symptom", use the diagnosis tool for a monitor check of the
mode flags during start-up, such as the coolant temperature, rail
pressure, SCV current value and battery voltage. (Refer to page
1-S27)
9Y3200007CRS0034US0
9. Check the Engine
1. Check the compression pressure, valve timing and the inside of
the engine.
9Y3200007CRS0035US0
OK Go to "9. Check the Engine".
NG Repair the malfunction.
(a) CAN1 Connector
OK Normal.
NG Repair the malfunction.
(1) Compression Tester
KiSC issued 03, 2022 A