EasyManua.ls Logo

Kurzweil PC2 Series - Description of Diagnostic Tests

Kurzweil PC2 Series
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-4
Diagnostics
Description of Tests
Description of Tests
ROM
This test checks the software data (engine, boot, and setups) stored in FlashROM on the Engine
Board.
A failure of this test may indicate a problem with the Flash ROM chip (U5 on the Engine Board),
associated circuitry, or the Engine Board.
Read-write
This test is a combination of the RAM, MABEL and LISA tests. The Read-write test writes data
to RAM and the MABEL and LISA registers then conrms that the data written can be read back
successfully.
A failure of this test indicates a problem with the Engine Board.
RAM
The RAM test writes to the microprocessor RAM space and veries that the write was
successful.
A failure of this test may indicate a problem with the RAM or related circuitry on the Engine
Board.
MABEL
This test performs a read-write of the MABEL registers and veries that the data written can be
read back successfully.
A failure of this test may indicate a problem with a MABEL, related circuitry or the Engine
Board.
LISA
This test conrms that the Lisa chip (U15) is properly installed and successfully interfacing with
the microprocessor.
A failure of this test indicates a problem with Lisa, related circuitry or the Engine Board.
Sound ROM
This test conrms that the Sound ROMs can be read by the MABELs by performing a checksum
of the Sound ROMs. The computed checksum is then compared to the stored checksum.
A failure of this test may indicate a problem with a Sound ROM (U19 or U20), or the Engine
Board.

Table of Contents

Related product manuals