Kurzweil PC2 Series User Manual

PC2/PC2X Disassembly/Assembly
Opening the PC2/PC2X
4-3
PC2X Bottom
Refer to Figure 4-2. Arrows indicate the locations of the enclosure support wall, endcap and rear
panel screws.
Figure 4-2 PC2X bottom enclosure
Caution: Do not remove the endcap or rear panel screws at this point of the procedure.
1. Tilt the PC2X up and remove the eight enclosure support wall screws.
2. Place the unit flat on your work surface.
3. Move the unit so that the rear panel portion of the unit hangs over the edge of your work
surface. This gives you access to the nine screws that secure the rear panel portion of the
top enclosure to the bottom enclosure. Remove the nine screws.
Note: Two of the rear panel screws also secure the rear panel edge of the access panel. It is
not necessary to remove the five remaining access panel screws.
4. Slide the unit back onto the work surface.
Access panel
Rear panel screws
Rear panel
Keyboard
Endcap screws
*
Endcap screws
*
*Endcap locking bracket screws
Enclosure support wall screws

Kurzweil PC2 Series Specifications

General

Polyphony	64 voices
Sound Engine	VAST (Variable Architecture Synthesis Technology)
MIDI	In, Out, Thru
Multitimbral	16 parts
Velocity Sensitivity	Yes
Aftertouch	Yes
Year Released	1999
Display	LCD
Controllers	Pitch wheel, modulation wheel
Inputs	Sustain pedal, expression pedal
Memory	128 setups
Keyboard	76-note, semi-weighted
Outputs	Stereo outputs, headphone output