PC2R Disassembly/Assembly
Opening the PC2R
3-7
Caution: Be sure to look for the marking on the edge of the cable denoting Pin 1 and that
you match it correctly with Pin 1 on the board. Make certain that the wires are straight
prior to inserting them into the connector and that each wire is correctly inserted into its
respective position.
Note: Be sure the sides of the connector are lifted. Insert the flat ribbon cables into the
wire trap connectors and push down the sides of each connector to lock the cable into the
connector. Gently pull each cable to verify that it is locked into its connector.
Insert the five-wire flat ribbon cable from the Connector Board into the wire trap
connector at J412 on the Engine Board.
Insert the ten-wire flat ribbon cable from the Connector Board into the wire trap connector
at J403 on the Engine Board.
7. Connect the flat ribbon cable from the Right Front Panel Board to J304 on the Connector
Board. Be sure to install the cable locking clip.
8. If you removed a PCX-1 Board, install it following the procedure on page 3-5.
To Next Page
Loading...
