Kyocera ECOSYS P8060cdn - Offset Documents by Job

8-19
Setup and Registration (System Menu) > System Menu
Manual Staple
[System Menu/Counter] key > [Common Settings] > [Manual Staple]
Offset Documents by Job
[System Menu/Counter] key > [Common Settings] > [Offset Documents by Job]
Printing Jobs
Bates Stamp Select whether to print a bates stamp on all printing jobs.
Value: Off, On
NOTE
When [On] is selected, the Bates Stamp settings cannot be changed when printing.
Edit Bates Stamp Set the default Bates Stamp.
Value: Date, User Name, Serial Number, Numbering, Text 1, Text 2, Date Format,
Numbering Default, Position, Font
NOTE
To set [Text 1] or [Text 2], select [Change] below and enter a maximum of 32
characters for the text string.
To set [Date], select [Date Format] and set the date display format.
To set [Numbering], select [Numbering Default] and set the starting sequence
number (1 to 9999999). If you select [Fixed Digit Number] > [On], you can set the
number of digits of the serial number (1 to 7 digits).
Select [Detail] in "Position" to specify the detailed stamp position using numeric
values, and to set the stamp position to be placed on the back side of the paper in
duplex printing.
NOTE
Only displayed when the optional 4,000-Sheet Finisher is installed.
Item Description
Manual Staple Select whether to use Manual Staple.
Value: Off, On
NOTE
If you selected [On], set the time until manual stapling mode is automatically
cancelled. The setting range is 5 to 60 seconds (in 5-second increments).
Staple Position Set the default Staple Position.
Value: A4, Letter
Item Description
Offset Documents by Job Select whether to offset documents by Job.
Value: Off, On
NOTE
This function is displayed when an optional Document Finisher is installed.
Item Description