Kyocera ECOSYS P8060cdn - Page 256

8-36
Setup and Registration (System Menu) > System Menu
Wired Network Settings
[System Menu/Counter] key > [System/Network] > [Network] > [Wired Network Settings]
Configure wired network settings.
TCP/IP Setting
Item Description
TCP/IP Select whether to use TCP/IP Protocol.
Value: Off, On
IPv4 Set up TCP/IP (IPv4) to connect to the network. This setting is available when [TCP/
IP] is set to [On].
IP Address Set the IP address.
Value: ###.###.###.###
NOTE
When DHCP is set to [On], this function will be grayed out and the value cannot be
entered.
Subnet Mask Set the IP subnet mask.
Value: ###.###.###.###
NOTE
When DHCP is set to [On], this function will be grayed out and the value cannot be
entered.
Default Gateway Set the IP gateway address.
Value: ###.###.###.###
NOTE
When DHCP is set to [On], this function will be grayed out and the value cannot be
entered.
DHCP Select whether to use the DHCP (IPv4) server.
Value: Off, On
Auto-IP Select whether to use Auto-IP.
Value: Off, On
IMPORTANT
• When setting the Auto-IP, enter "0.0.0.0" in [IP Address].
• After changing the setting, restart the network or turn the machine OFF and then ON.